2HP Water Cooled Spindle for HD4 and prior

Featuring auto start and stop and the ability to control motor speeds directly within the Vectric software Requires 10.5 or higher)

This spindle is ultra-quiet with long-life bearings and is designed for harsh environment operations. This spindle is 110V AC and will plug directly into the wall socket (requires a 15 amp circuit). Kit includes everything needed to work on SHARK CNC HD models.

• Spindle clamps for mounting included with kit - CNC SHARK HD SPINDLE CLAMP  
• 2hp (1.5Kw) liquid-cooled brushless Spindle.
• 8,000 - 24,000 RPM max 110V 13 amp inverter with digital readout display
• Digital interface cable to allow full auto control
• Er11 Collet system includes 1/4" and 1/8" shank collets
• Coolant hoses and fittings
• Submersible 110V fluid pump for coolant.
• Pre-programmed VFD - ready to run

This kit is for these older Next Wave CNC SHARK CNC HD Series models

• HD 4
• HD 4 Extended bed
• Shark II/HD400
• HD 3
• HD 3 Extended bed
• Slimline
• HD 2
• HD 2 Black Diamond
• HD 2 Mako
• Rockler Anniversary Edition