Support Mike

One of the first things that will need to be determined is which machine we are working with and whether it comes with an LCD pendant.   MACHINE IDENTIFICATION / REGISTRATION: If the machine is an ...

When attempting to cut a design and then run a laser toolpath to trace the toolpath of the cut design, it is important to get the starting points (zero points) of both toolpaths to align with one a...

When the HD control box is powered on, the LCD pendant should light up and display a grey 'Continue' button.   If the grey 'Continue' button is unresponsive when tapped or pushed and does not turn...

When creating a file (project) in VCarve / Aspire, you are creating something called a CRV file. This is the reworkable file that is created while you are building or modifying that particular file...

Shark SD101 User's Manual

  If the X-axis or Z-axis travel seizes up while trying to move or while cutting a file, the bearing boxes may need to be flushed out and then greased. Inside the bearing boxes are bearings that mo...

Creating a Simple Raster File in Ready2Raster   Ready2Raster can be opened by double-clicking on the Ready2Raster icon on your desktop.   The Shark Logo used in these steps can be downloaded for u...

Ready2Raster Installation   Ready2Raster is downloaded from your Next Wave portal account and can be downloaded again from your portal account in the event you need the software on a new computer. ...

Installing Ready2Update Firmware   Ready2Update Firmware is downloaded from your Next Wave portal account and can be downloaded again from your portal account in the event you need the software on ...

Entering Boot Mode during a Firmware Update While conducting a firmware update on your control box, you may be prompted to put your control box into Boot Mode. 'Boot Mode' is the state in which a N...