Support Mike

There are (4) steps required to save a location for the fence and/or the lift on the RS1000 pendant.   The first step is to physically jog or position the lift or fence into the position desired.  ...

One of the first things that will need to be determined is which machine we are working with and whether it comes with an LCD pendant.   MACHINE IDENTIFICATION / REGISTRATION: If the machine is an ...

When attempting to cut a design and then run a laser toolpath to trace the toolpath of the cut design, it is important to get the starting points (zero points) of both toolpaths to align with one a...

When the HD control box is powered on, the LCD pendant should light up and display a grey 'Continue' button.   If the grey 'Continue' button is unresponsive when tapped or pushed and does not turn...

When creating a file (project) in VCarve / Aspire, you are creating something called a CRV file. This is the reworkable file that is created while you are building or modifying that particular file...

Shark SD101 User's Manual

  If the X-axis or Z-axis travel seizes up while trying to move or while cutting a file, the bearing boxes may need to be flushed out and then greased. Inside the bearing boxes are bearings that mo...

Entering Boot Mode during a Firmware Update While conducting a firmware update on your control box, you may be prompted to put your control box into Boot Mode. 'Boot Mode' is the state in which a N...

Conducting a Firmware Update on the Pendant   To keep both the LCD Pendant and Main Control Box communicating properly, a firmware update to one should be followed up with an update to the other.  ...

Conducting a Firmware Update on the Controller   To keep both the Main Control Box (Controller) and LCD Pendant communicating properly, a firmware update to one should be followed up with an update...