Support Scott Baumeister

  • Total activity 38
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 3 users
  • Votes 1
  • Subscriptions 19

Activity overview

Latest activity by Support Scott Baumeister
  • Support Scott Baumeister created an article,

    15 Pin VGA Cable for the LCD Pendant

    The 15 Pin VGA cable used by Next Wave CNC to connect the main control box to the LCD Pendant is not a commonly found version of this cable. The VGA cable used by Next Wave CNC uses 1:1 pin wiring ...

  • Support Scott Baumeister created an article,

    Pre HD4 Shark Owners Manual

     MANUAL: CNC Shark Pre-HD4 Owners Manual CNC Shark HD3 Compatible Routers: Bosch 1617 and 1618 Porter-Cable 890 Series Porter-Cable 690 Series (6902VS must be manually started) DeWalt 610...

  • Support Scott Baumeister created an article,

    HD4 X Axis T-Nut Replacement

    -------------------HD4: Changing out a X axis T-nut-------------------You will need: · A drill or multi head screw driver · Ph#2 Phillips driver bit · 5/32 Allen wrench or driver bit · Loctite · ...

  • Support Scott Baumeister created an article,

    SD120 / Piranha XL not starting Router

    The standard Piranha post-processors do not have the Gcode commands to start the router. Please use the CNC Shark USB Arcs inch.pp or Next Wave CNC inch.pp post processors when saving the toolpath ...

  • Support Scott Baumeister created an article,

    Contact Technical Support

    Technical Support -   M-F  9:00 am to 5:00 pm Eastern  Start an online email ticket -  https://www.nextwavecnc.com/support  Phone (419) 318-4822  Email -  support@nextwavecnc.com

  • Support Scott Baumeister created an article,

    Ready2Rout System Manual

    Download the attached PDF File.    

  • Support Scott Baumeister created an article,

    Control Panel 2.1 - Download & Registration

    The Shark Control Panel 2.1 registration has been changed to stop the yearly registration requirement. Please use the steps below to install and register CNC Shark Control Panel 2.1.    1. Install...

  • Support Scott Baumeister created an article,

    Ready2Rout - Quick Start Connections

    Cabling: Always have the system powered OFF when connecting and disconnecting the 9 pin and 15 pin cables.  Electronics will blow if this is not done!  Only one power supply is needed for the sy...

  • Support Scott Baumeister created an article,

    Sense Probe Owner's Manual

    Download the attached PDF File. (Discontinued item)

  • Support Scott Baumeister created an article,

    Digital Duplicator for Next Wave CNC machines

    Current under redesign - unavailable The Digital Duplicator is a great accessory that enables the machine to scan an object through a series of "touches" across that object. Once the object has bee...