Scott Latham

  • Total activity 146
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 3 users
  • Votes 0
  • Subscriptions 76

Activity overview

Latest activity by Scott Latham
  • Scott Latham created an article,

    Shark

    Original Shark CNC   XYZ travel   Std deck: 13" x 24" x 4" Power Requirements   120V, 60Hz, 10A fuse, Single Phase Generator/UPS requirements   CNC machine alone: 4A, 120V or 480W   w...

  • Scott Latham created an article,

    Shark Pro & Pro Plus

    Shark Pro Plus   Shark Pro   XYZ travel   Std deck: 24" x 24" x 4" Power Requirements   120V, 60Hz, 10A fuse, Single Phase Generator/UPS requirements   CNC machine alone: 4A, 120V or ...

  • Scott Latham created an article,

    Shark Pro Plus HD

    Shark Pro Plus HD   XYZ travel   Std deck: 25" x 25" x7" Power Requirements   120V, 60Hz, 10A fuse, Single Phase Generator/UPS requirements   CNC machine alone: 4A, 120V or 480W   w/ R...

  • Scott Latham created an article,

    HD2 Series

    Shark HD2 Series Special editions include: Black Diamond   Mako XYZ travel   Std deck: 25" x 25" x7"   Ext deck: 25" x 48" x 7" Power Requirements   120V, 60Hz, 10A fuse, Single Phase ...

  • Scott Latham created an article,

    Slimline

    Slimline CNC   XYZ travel   16" x 36 "x 7" Power Requirements   120V, 60Hz, 10A fuse, Single Phase Generator/UPS requirements   CNC machine alone: 4A, 120V or 480W   w/ Router: 10A, 12...

  • Scott Latham created an article,

    Shark HD3 Series

    HD 3 Series Special editions include: Rockler Anniversary Edition   XYZ travel   Std deck: 25" x 25" x7"   Ext deck: 25" x 50" x 7" Power Requirements   120V, 60Hz, 10A fuse, Single Phase...

  • Scott Latham created an article,

    VFD/Inverter

          The VFD/Inverters in the 2HP spindle kits (20157 / 20004) and the 3HP spindle kit all come pre-programmed and are ready to go right out of the box. With the introduction of the digital inter...

  • Scott Latham created an article,

    Spindle Collet Assembly

    When using the water-cooled spindles, the collet and nut must be assembled correctly otherwise, numerous issues can occur. Issues such as threads stripping, the bit being pulled out of the collet d...

  • Scott Latham created an article,

    2HP Water Cooled Spindle for HD4 and prior

    Featuring auto start and stop and the ability to control motor speeds directly within the Vectric software Requires 10.5 or higher) This spindle is ultra-quiet with long-life bearings and is design...

  • Scott Latham created an article,

    Starting example Bit settings

       Feeds and speeds are a big topic in the CNC community and can be very confusing or overwhelming when getting started. Using the 6-Piece Starter bit set, this article will provide you with a star...